User guide
Automatic gap adjustment
(AGA)
Formlen AGA
Back
Next
1
2
3
4
AGA=always
*
Set
<
>
Exit
1
2
3
4
Paper handling (Paphand)
Paphand CX-bid
Back
Next
1
2
3
4
Head up Pagewid
Back
Next
1
2
3
4
This function allows you to switch the Automatic Gap Adjustment
(AGA) off or on.
Select the AGA menu (3).
Online
Setup
Setting options: Off/once/always
Default setting:
Online
AGA=always: The printer checks the paper thickness:
– after power-on
Setup
– in single-sheet mode: every sheet
– in fanfold paper mode: each time the paper path is changed and
atpaper end.
AGA=once: The printer checks the paper thickness only once after-
power-on for each selected paper path and after paper end.
AGA=Off: selects manual gap adjustment; the value can be set for
eachpaper source and each of the 3 menus available.
Confirm the setting by pressing the Set (1) key. The printer automat-
ically leaves test mode and assumes online mode.
The Paphand group of menus improves the possibilities for the trou-
blefree printing of paper with properties likely to cause problems
(perforations etc.) or paper of poor finish.
Put the printer into Test mode by pressing the key Online while
switching on the printer. The display shows ASCII80 ASCII136.
Change to the parameter group Formlen AGA by pressing the key
Next three times.
Select the Paphand menu (1).
Online
Setup
Select the Head up menu (2).
Online
Setup
always
Advanced menu
85
Need help?
Do you have a question about the T2150 and is the answer not in the manual?