Messages In The Lc Display - Dascom Tally T2380 User Manual

User guide
Messages in the LC
display
If the printer detects an internal fault or user error or if it expects you
to do something, a message will appear in the LC display. It also dis-
plays the status during an operation (e.g. Initializing). Below you
will find a list of messages with brief descriptions of each message.
The messages are described in greater detail in the chapter
messages via the display (page
Message
Eject error
Hardware Alarm
Initializing
Load error
Load paper from
Loading default
Out of paper
Paperwidth error
Parity error
Park position
Press any key
PW sensor defect
Selftest
The control panel
122).
Meaning
The printer cannot eject the paper/
advance it to park position.
Internal hardware error. Try power
cycling the printer. If the message
appears again, contact your dealer or
service technician.
This message appears during the
printer's initializing phase after switch-
ing on the printer.
The printer cannot draw in the loaded
paper.
The printer has detected paper end
during operation/printer was switched
on with no paper loaded.
Factory defined parameters will be
reloaded in all available menus after
switching on the printer.
The printer has detected paper end
during operation / printer was switched
on with no paper loaded.
Print characters override the detected
right paper margin.
A parity error during data transmission
is indicated.
Paper is not being fed into print posi-
tion.
The user is requested to press any
key.
The automatic paper width detection
cannot detect the left paper margin.
After power-on, the printer executes a
short hardware self-test.
Error
35