Eaton Powerware 9140 User Manual page 61

13. Replace the input and output terminal block covers.
14. If your rack has conductors for grounding or bonding of ungrounded
metal parts, connect the ground cable (not included) to the ground
bonding screw. See Figure 28 on page 47 for the location of the
ground bonding screw.
NOTE DO NOT protect laser printers with the UPS because of the exceptionally high power
requirements of the heating elements.
NOTE Verify that the total equipment ratings do not exceed the UPS capacity to prevent an
overload alarm.
15. Plug the equipment to be protected into the UPS output
receptacles, but do not turn on the protected equipment (see
Figure 28 on page 47).
16. Make any necessary provisions for cord retention and strain relief.
17. If an emergency power-off (disconnect) switch is required by local
codes, see "REPO and ROO Installation" on page 54 to install the
REPO switch before powering on the UPS.
If you are not required to install a REPO switch, you can install an
optional remote on/off (ROO) switch (see page 54).
18. Switch all circuit breakers to the ON (
19. Switch the main utility breaker on.
The
with the equipment offline. The fans run and the LCD illuminates
and displays the UPS startup screens.
20. To change the factory-set defaults, see "User Settings" on
page 60.
®
EATON Powerware 9140 UPS (7.5–10 kVA) User's Guide
indicator flashes, indicating the UPS is in Standby mode
S
164201622 Rev A FINAL DRAFT 14-Jul-2006
INSTALLATION
|
) position.
53