Eaton Powerware 9140 User Manual page 51

7.5-10 kva ups

Hide thumbs Also See for Powerware 9140:

Table of Contents

NOTE DO NOT protect laser printers with the UPS because of the exceptionally high power

requirements of the heating elements.

NOTE Verify that the total equipment ratings do not exceed the UPS capacity to prevent an

overload alarm.

Plug the equipment to be protected into the UPS output

receptacles, but do not turn on the protected equipment (see

Figure 27).

Make any necessary provisions for cord retention and strain relief.

If an emergency power-off (disconnect) switch is required by local

codes, see "REPO and ROO Installation" on page 54 to install the

REPO switch before powering on the UPS.

If you are not required to install a REPO switch, you can install an

optional remote on/off (ROO) switch (see page 54).

Switch all circuit breakers to the ON (

Plug the UPS input power cord into an IEC 309-60A power outlet.

The

with the equipment offline. The fans run and the LCD illuminates

and displays the UPS startup screens.

EATON Powerware

9140 UPS (7.5–10 kVA) User's Guide

indicator flashes, indicating the UPS is in Standby mode

164201622 Rev A FINAL DRAFT 14-Jul-2006

INSTALLATION

) position.

Table of Contents