Eaton Powerware 9140 User Manual page 42

INSTALLATION
The UPS is heavy (see page 85). A minimum of two people are required to remove the UPS
from its carton.
7.
8.
Figure 19. Removing the UPS Front Cover and Electronics Module
34
EATON Powerware
Place the UPS on a flat, stable surface with the front of the UPS
facing toward you.
Remove the UPS front cover and the electronics module and set
them aside (see Figure 19):
To remove the UPS front cover, loosen the two front cover screws.
Grasp the fingergrips on both sides of the cover and pull the cover
forward firmly.
To remove the electronics module, turn the module lock switch to the
UNLOCK position. Grasp the handle at the bottom of the module
and pull the module slowly out of the cabinet. Use two hands to
support the module.
®
9140 UPS (7.5–10 kVA) User's Guide
C A U T I O N
S
164201622 Rev A FINAL DRAFT 14-Jul-2006