Eaton Powerware 9140 User Manual page 34

INSTALLATION
11. If installing the optional seismic mounting brackets, align the two
Figure 8. Installing the Optional EBM Seismic Mounting Brackets
12. Slide the EBM into the rack. Verify that the rear mounting brackets
13. Secure the front of the cabinet to the rack as shown in Figure 9.
26
EATON Powerware
EBM seismic mounting brackets with the screw holes on the sides
of the EBM above the rear mounting brackets. Loosely secure the
brackets with four supplied wing bolts. See Figure 8.
Do not tighten the wing bolts.
engage in and slide easily along the inside of the rails.
If the rack holes are square, use two cage nuts. If the rack holes are
round, use two clip nuts.
Figure 9. Securing the Front of the EBM
®
9140 UPS (7.5–10 kVA) User's Guide
S
164201622 Rev A FINAL DRAFT 14-Jul-2006
Position 8 (M6 screw
and clip/cage nut)
Position 3 (M5 screw)
Position 2 (M5 screw)