Projector Communications; Status Leds - Christie M Series User Manual

Section 2: Installation and Setup

2.10 Projector Communications

2.10.1Status LEDs

Looking from the back of the projector, the LEDs represent, from left to right; Lamp 1, Lamp 2, Power, and
Status. The LEDs will display the colors as shown below:
PROJECTOR STATE
Hard Boot
Standby Mode
Warm-up (Powering ON from standby)
Normal Operation
Cool-down
Error
Software Upgrade in progress
Lamp Regeneration in progress
NOTE: A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
The Status LEDs are cycling green
•
The LCD displays the warning "Image Processor Upgrading"
•
The LED on the Image Processor card flashes green
•
The Web page shows a warning that the Image processor card is upgrading.
•
When this occurs, the projector should not be AC power cycled and the Image Processor card should not be removed.
2-26
LEDS LED STATE
All All LEDs amber
Lamp 1 and 2 Off
- lamps are off
Power Amber
standby
Shutter Green
Amber
All LEDs cycle green from left to right
Lamp 1 and 2 Amber
be replaced
Power Green
normally
Shutter Green
Amber
All LEDs cycle amber from left to right
Amber
be replaced
Lamp 1 and 2
Flashing Red
Flashing Red
Power
displayed on the status display
All The pattern will alternate between:
Amber
Lamp 1 and 2 Flashing Green
off for its regeneration period to extend lamp life
(typically 15 minutes every 24 hours)
Power Green
-OR-
Amber
Shutter Green
- means please wait
- AC is present but projector is off or
- shutter is open
- shutter is closed
- lamp time has expired and lamp should
- projector is powered up and operating
- shutter is open
- shutter is closed
- lamp time has expired and lamp should
- lamp has malfunctioned
- error has occurred. Details are
Off
and
- the lamp is being switched
- on
- standby
- shutter is open
M Series User Manual
020-100009-08 Rev. 1 (05-2013)