Christie M Series User Manual page 67

To Edit A Channel: Press M
Channel Setup menu, press 3 or move the highlight to the Channel Setup option and press E
Channel Setup menu will appear.
1. To edit parameters shown in the Channel Setup menu, select the relevant channel and press E
Channel Edit menu will appear similar to the sample shown below.
2. If desired, review and/or edit the following channel setups in the Channel Edit menu:
• Name: An alphanumeric label can be defined and/or changed here. Channel names can be up to 12 charac-
ters in length. The default name is the horizontal and vertical sync frequencies.
• Channel: A two-digit channel number can be changed here.
NOTES: 1) If you enter a channel number that already exists, a dialog message appears indicating that
this number is already in use; assign a different channel number. 2) You can define up to 99 channels.
• Slot: 1-4, corresponding to which slot in the projector's input panel the source is connected:
• Input: 1-6, corresponding to which input on the selected slot the source is connected to.
• In Menu: If checked (default, except for automatically defined channels with unchanged parameters), this
defined channel will then appear in the list available when C
channel must be accessed via C
NOTE: On-screen display of the channel list is an option that must be set in the Menu Preferences menu.
• Auto Select: If checked, (default), the projector can automatically locate this channel when an incoming
input signal matches. If not checked, the projector can locate the selected channel only when it is directly
selected via C
• Locked: If checked, all of the image settings for this channel are locked. If unchecked (default), all avail-
able image settings can be adjusted as desired. You cannot use Auto Setup with a locked channel.
• Previous Channel: Select this option to see or change Channel Edit settings for the previous channel in
the Channel Setup list.
• Next Channel: Select this option to see or change Channel Edit settings for the next channel in the
Channel Setup list.
M Series User Manual
020-100009-08 Rev. 1 (05-2013)
ENU
from the presentation level to display the Main menu. To display the
HANNEL
HANNEL
on the keypad; a change in input signal will not result in a channel change.
HANNEL
on the keypad or via the Auto Source function.
Section 3: Operation
NTER
key is pressed. If unchecked, the
. The
NTER
. The
3-17