Table of Contents
Advertisement
Section 2: Installation and Setup
2.3
Projector Communications
2.3.1 Status LEDs
Looking from the back of the projector, the LEDs represent, from left to right; Lamp, Communications, Status,
and Shutter. The LEDs will display the colors as shown below:
STATUS LED
Lamp
Comm
Status
Shutter
NOTE: A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
The Status LEDs are cycling green
•
The LCD displays the warning "Image Processor Upgrading"
•
The LED on the Image Processor card flashes green
•
The Web page shows a warning that the Image processor card is upgrading.
•
When this occurs, the projector should not be AC power cycled and the Image Processor card should not be removed.
2-10
LED #
LED STATE
Off
- Lamps are off
Yellow
- Lamp time has expired and lamp should be replaced
Green
1
- Lamp is on and operating correctly
Flashing Red
Flashing Yellow
2
Flashing Green
Off
- AC power is off
Yellow
- AC is present but projector is in standby
3
Green
- Projector is powered up and operating normally
Flashing Red
Green
- Shutter is open
4
Yellow
- Shutter is closed
- Lamp has malfunctioned
- Lamp door is open
- Projector communication in progress
- Error has occurred. Details are displayed on the status display
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-03 Rev. 1 (02-2014)
Advertisement
Table of Contents
