Separate Networks; Communicate To All Ports - Christie M Series User Manual

baud rate. See Section 3 Operation
set the Network Routing to RS-232 and RS-422 Joined.
NOTES: 1) Connect only high quality, properly wired serial communication cables. 2) Each RS-232
communication cable should be no more than 50 feet in length.
Ethernet Network Setup: To add one or more projectors to an Ethernet network, use standard CAT5 cables to
connect each projector Ethernet port to a hub on the network. A controller or PC must also be connected to the
hub.
NOTE: A wireless router can be used to communicate to the projectors via 802.11b/g.
Setting the Projector IP Address, Subnet Mask and Gateway: See
Parameters and Advanced Controls.
Changing the Port Number: On some Ethernet networks, firewall restrictions may require that the port
number of the projector be changed from the default of 3002. If so, enter a new port number in the Ethernet
Settings menu or include the new port number.

2.9.7 Separate Networks

By default, communications which originate from one type of serial controller—RS-232 vs. RS-422 vs.
Ethernet—stay on the corresponding network path. A "separate" setting indicates this separation for Network
Routing in the Communications menu, see
controller, for example, it will communicate only with the projector to which it is connected unless you change
this setting to either RS-232 and RS-422 Joined or All Joined.

2.9.8 Communicate to all Ports

To relay all messages to all ports—RS-232, RS-422, and Ethernet—set the Network Routing option in the
Communications menu for each projector to All Joined, see
is useful if you are using a non-RS-232 controller with the RS-232 linking available between these projectors.
M Series User Manual
020-100009-08 Rev. 1 (05-2013)
for help changing the projector baud rate. To communicate to all projectors,
Section 4 Web User
Section 2: Installation and Setup
3.7 Configuration - Adjust System
Interface. If you are using an RS-422
Section 4 Web User Interface. This configuration
2-23