Connect Tiled Projectors - Christie M Series User Manual

Section 2: Installation and Setup

2.11.8Connect Tiled Projectors

Wiring Requirements
A distribution box or digital signal switcher may be used to feed the same video signal to all the units of the
tiling array.
Christie loop-through may be used to set up a tiling array (see Figure 2-7 to Figure 2-12). The system allows
wiring (providing the HDCP requirement is met) when HDCP is used by the source. The cascade level of
devices must be no more than 7 levels deep.
NOTE: If single wire loop-through is used (See Figure 2-11), then PIP is not supported.
The wiring diagrams are provided to:
• Meet the HDCP requirement,
• Minimize the length of HDMI cables to be used, and
• Balance the connection tree to ensure the level of loop-through is minimized.
NOTE: This is to enable the downstream projectors to finish source switches in a minimum amount of time.
(Applicable to arrays with HDCP only)
2-30
F 2-7 U D
IGURE SE OF ISTRIBUTION
B
OX
M Series User Manual
020-100009-08 Rev. 1 (05-2013)