Projector Communications; Status Leds - Christie HD14K-M2 Quick Start Manual

Projector communications

Status LEDs

Looking from the back of the projector, the LEDs represent, from left to right; Lamp 1, Lamp 2,
Power, and Status. The LEDs display the colors as shown below:
Projector states
Hard Boot
Standby Mode
Warm-up (Powering ON from standby)
Normal Operation
Cool-down
Error
Software Upgrade in progress
Lamp Regeneration in progress
M Series Quick Start Guide
020-101941-01 Rev. 1 (07-2015)
LEDS LED state
All All LEDs amber - means please wait
Lamps 1 and 2 Off—lamps are off
Power Amber—AC is present but projector is off or
standby
Shutter Green—shutter is open
Amber—shutter is closed
All LEDs cycle green from left to right
Lamp 1 and 2 Amber—lamp time has expired and lamp
should be replace
Power Green—projector is powered up and
operating normally
Shutter Green—shutter is open
Amber—shutter is closed
All LEDS cycle from left to right
Lamp 1 and 2 Amber—lamp time has expired and lamp
should be replaced
Flashing Red—lamp has expired and lamp
should be replaced
Power Flashing Red—error has occurred. Details
are display on the status display.
All The pattern will alternate between:
Amber and Off
Lamp 1 and 2 Flashing Green—the lamp is being switched
off for its regeneration period to extend lamp
life (typically 15 minutes every 24 hours)
Power Green—on
Amber—standby
Shutter Green—shutter is open
Installation and Setup
20