Projector Communications - Christie M Series User Manual

2.2.10 Projector Communications

Status LEDs
Looking from the back of the projector, the LEDs represent, from left to right; Lamp 1, Lamp 2, Power, and
Status. The LEDs will display the colors as sho wn below:
Projector State
Hard Boot
Standby Mode
Warm-up (Powering ON from standby)
Normal Operation
Cool-down
Error
Projector State
Software Upgrade in progress
Lamp Regeneration in progress
NOTE: A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
• The Status LEDs are cycling green
• The LCD displays the warning "Image Processor Upgrading"
• The LED on the Image Processor card flashes green
• The Web page shows a warning that the Image processor card is upgrading.
When this occurs, the projector should not be AC power cycled and the Image Processor card should not be removed.
M Series User Manual
020-100009-04 Rev. 1 (10-2009)
LEDs
All All LEDs amber - means please wait
Lamp 1 & 2 Off - lamps are off
Power Amber - AC is present but projector is off or standby
Green - shutter is open
Shutter
Amber - shutter is closed
All LEDs cycle green from left to right
Lamp 1 & 2 Amber - lamp time has expired and lamp should be
replaced
Power Green - projector is powered up and operating normally
Green - shutter is open
Shutter
Amber - shutter is closed
All LEDs cycle amber from left to right
Amber - lamp time has expired and lamp should be
Lamp 1 & 2 replaced
Flashing Red - lamp has malfunctioned
Power Flashing Red - error has occurred. Details are displayed
on the status display
LEDs
All The pattern will alternate between:
Amber, Off, Amber, Off
and
Off, Amber, Off, Amber
Lamp 1 & 2 Flashing Green - the lamp is being switched off for its
regeneration period to extend lamp life (typically 15 min-
utes every 24 hours)
Power Green - on
or
Amber - standby
Shutter Green - shutter is open
Section 2: Installation and Setup
LED State
LED State
2-25