Projector Communications - Christie 1000W J Series Setup Manual

2.2.5 Projector Communications

Status LEDs
Looking from the back of the projector, the LEDs represent, from top to bottom; Shutter, Status, Comm, and
Lamp. The LEDs will display the colors as shown below:
Status LED
(located at back of projector)
Shutter
Status
Comm
Lamp
NOTE: A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
• The Status LEDs are cycling green
• The LCD displays the warning "Image Processor Upgrading"
• The LED on the Image Processor card flashes green
• The Web page shows a warning that the Image processor card is upgrading.
When this occurs, the projector should not be AC power cycled and the Image Processor card should not be removed.
J Series 1000W & 1200W Setup Guide
020-100740-02 Rev. 1 (03-2014)
#
1 Green - Shutter is open
Yellow - Shutter is closed
2 Off - AC power is off
Yellow- AC is present but projector is in standby
Green - Projector is powered up and operating normally
Flashing Red - Error has occurred. Details are displayed
on the status display.
3 Flashing Green - Projector communication in progress
4 Off - Lamp off
Yellow - Lamp time has expired and lamp should be
replaced
Green - Lamp is on and operating normally
Flashing Red - Lamp has malfunctioned
Flashing Yellow - Lamp door is open
Section 2: Installation and Setup
LED State
2-9