Christie M Series User Manual page 126

Section 5: Maintenance
a. Unscrew the 3 captive screws securing the lamp using a #1 Phillips® screwdriver.
b. Carefully remove the lamp from the projector. Place the old lamp in a location where it cannot fall or
be bumped.
5. To use lamp OFF command:
a. In the lamp menu, select Change Lamp. This will prompt for the old lamp serial number (if it was not
previously entered).
b. Enter the new lamp serial number.
NOTE: This action is not mandatory, it is recommended for accurate lamp statistics to be archived.
6. Install the new lamp:
a. Take precaution to align the new lamp properly in the correct orientation inside the projector.
b. Press firmly to seat the lamps, ensuring the lamp is secure.
c. Using the Phillips screwdriver and captive screws secure the lamp door and tighten the captive screw.
NOTES: 1) If the lamps were turned off with the OFF command in step 1, they will have to be manually
turned on. 2) If the lamps were turned off by opening the door, then they will automatically turn on again
when the door is closed.
5-4
Handle lamps with extreme caution. Dispose of lamps according to safety
regulations for your area.
M Series User Manual
020-100009-08 Rev. 1 (05-2013)