Power Down; Remote Keypad/Built-In Keypad; Web User Interface (Ui) - Christie M Series User Manual

11. Lock the setscrews, and re-check the boresight quality. Tighten the setscrew enough to ensure they will not
shift.
2.8

Power Down

The projector can be powered down by using one
of the following methods:

2.8.1 Remote Keypad/Built-In Keypad

• Press and hold P
-OR-
• Press P
OWER
-OR-
• Press P
OWER
D
OWN
key.
NOTE: If the second key is not pressed immediately, a confirmation window will appear. The second key
must be pressed within 1 second of the window appearing.
After powering down, the Status LEDs will cycle, and the LCD displays the message "Cooling Down" until
cool down is complete.

2.8.2 Web User Interface (UI)

1. From the Main Tab, Select Power > OFF.
NOTE: A window will display for confirmation on powering down, see Figure 2-6.
2. Select Yes.
M Series User Manual
020-100009-08 Rev. 1 (05-2013)
F 2-5 P
IGURE
OWER
twice
once, then immediately press the
S F
OSITION ETSCREW LUSH
F 2-6 P
IGURE OWERING
Section 2: Installation and Setup
D /W U I
OWN EB SER NTERFACE
2-19