Projector Communications - Christie M Series Setup Manual

Section 2: Installation and Setup

2.2.6 Projector Communications

Status LEDs
Looking from the back of the projector, the LEDs represent, from left to right; Lamp 1, Lamp 2, Power, and
Status. The LEDs will display the colors as shown below:
PROJECTOR STATE
Hard Boot
Standby Mode
Warm-up (Powering ON from standby)
Normal Operation
Cool-down
Error
Software Upgrade in progress
Lamp Regeneration in progress
NOTE: A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
The Status LEDs are cycling green
•
The LCD displays the warning "Image Processor Upgrading"
•
The LED on the Image Processor card flashes green
•
The Web page shows a warning that the Image processor card is upgrading.
•
When this occurs, the projector should not be AC power cycled and the Image Processor card should not be removed.
2-10
LEDS LED STATE
All LEDs amber
All
Lamp 1 and 2 Off
- lamps are off
Power Amber
standby
Shutter Green
- shutter is open
Amber
All LEDs cycle green from left to right
Amber
Lamp 1 and 2
be replaced
Green
Power
- projector is powered up and operating
normally
Green
Shutter
- shutter is open
Amber
All LEDs cycle amber from left to right
Amber
be replaced
Lamp 1 and 2
Flashing Red
Power Flashing Red
displayed on the status display
All The pattern will alternate between:
Amber
Lamp 1 and 2 Flashing Green
off for its regeneration period to extend lamp life
(typically 15 minutes every 24 hours)
Power Green
- on
-OR-
Amber
Shutter Green
- shutter is open
- means please wait
- AC is present but projector is off or
- shutter is closed
- lamp time has expired and lamp should
- shutter is closed
- lamp time has expired and lamp should
- lamp has malfunctioned
- error has occurred. Details are
Off
and
- the lamp is being switched
- standby
M Series Setup Guide
020-100011-05 Rev. 1 (07-2012)