Table of Contents
Advertisement
Administration
Using Web Management
•
Current version displays the version number of code.
•
Local downloads an operation code image file from the Web management station to the access
point using HTTP. Specify the name of the code file in the New firmware file field, either:
–
–
–
•
Remote downloads an operation code image file from a specified remote FTP or TFTP server.
–
–
–
–
–
•
Restore Factory Settings resets the configuration settings to the factory default settings (all
configuration settings will be lost), and then you must reboot the system.
•
Reset Access Point reboots the system and retains your configuration settings.
4-40 Advanced Configuration
Use the Browse button to locate the image file locally on the management station.
Enter the name of the code file on the server. The new firmware file name should not
contain slashes (\ or /), the leading letter of the file name should not be a period (.), and
the maximum length for file names is 32 characters for files on the access point. (Valid
characters: A‐Z, a‐z, 0‐9, ".", "‐", "_").
Click Start Upgrade to download file.
Click the radio button beside FTP or TFTP server.
IP Address specifies the IP address or host name of FTP or TFTP server.
Username specifies the user ID for login on an FTP server.
Password specifies the password used for login on an FTP server.
Click Start Upgrade to download file.
Caution: If you restore factory defaults, all user configured information will be lost. You will have
to re-enter the default user name (admin) to regain management access to this device.
Note: If you have upgraded system software, then you must reboot the Access Point 3000 to
implement the new operation code.
Advertisement
Table of Contents
