Rogue-Ap Scan - Enterasys ROAMABOUT 3000 Configuration Manual

rogue-ap scan

This command starts a scan of both the 802.11a and 802.11g interfaces for neighboring access
points and for rogue aps, if rogue AP RADIUS is enabled.
Syntax
rogue-ap scan
Default Setting
None
Command Mode
Global Configuration
Command Usage
Use this command to scan all radio interfaces. Use the rogue‐ap [interface‐a] [interface‐g] interval
command to scan specified radio interfaces.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#rogue-ap scan
Related Commands
rogue‐ap enable page A‐159
rogue‐ap [interface‐a | interface‐g] scan page A‐163
rogue‐ap sortmode page A‐166
rogue‐ap radius page A‐164
RoamAbout Access Point 3000 Configuration Guide A-165
Command Groups