Enterasys ROAMABOUT 3000 Configuration Manual page 143

Table A-5 System Management Commands (continued)
Command
ip telnet-server
Event Logging
logging on
logging host
logging console
logging level
logging facility-type
show logging
show events
logging clear
System Clock
sntp-server ip
sntp-server enable
sntp-server date-time
sntp-server daylight-
saving
sntp-server timezone
show sntp
System Status
show system
show version
Function
Enables Telnet access to this access
point.
Controls logging of error messages
Controls logging of error messages
Adds a syslog server host IP address that
will receive logging messages
Initiates logging of error messages to the
console
Defines the minimum severity level for
event logging
Sets the facility type for remote logging of
syslog messages
Displays the state of logging
Displays all messages recorded in the
event log
Clears the event log of all messages.
Sets the system clock via an NTP/SNTP
server
Specifies one or more time servers
Accepts time from the specified time
servers
Manually sets the system date and time
Sets the start and end dates for daylight
savings time
Sets the time zone for the access point's
internal clock
Shows current SNTP configuration
settings
Displays system configuration and version
information
Displays system information
Displays version information for the
system
RoamAbout Access Point 3000 Configuration Guide A-17
Command Groups
Mode Page
GC A-30
GC A-31
GC A-31
GC A-33
GC A-34
GC A-35
Exec A-36
Exec A-37
GC A-38
GC A-39
GC A-40
GC A-41
GC A-42
GC A-43
Exec A-43
Exec A-44
Exec A-45