General Commands; Configure - Enterasys ROAMABOUT 3000 Configuration Manual

Command Groups

General Commands

The General commands are listed in Table
Table A-4 General Commands
Command

configure

end
exit
ping
reset
show history
show line
configure
This command activates Global Configuration mode. You must enter this mode to modify most of
the settings on the access point. You must also enter Global Configuration mode prior to enabling
the context modes for Interface Configuration. See "Accessing the CLI"
Default Setting
None
Command Mode
Exec
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#
Related Commands
end page A‐11
exit page A‐11
A-10
Function
Activates global configuration mode
Returns to Exec mode
Returns to the previous configuration mode, or exits
the CLI
Sends ICMP echo request packets to another node
on the network
Restarts the system
Shows the command history buffer
Shows the configuration settings for the console port
A‐4.
Mode Page
Exec A-10
GC, IC A-11
any A-11
Exec A-12
Exec A-13
Exec A-14
Exec A-15
on page A‐1.