QoS
Using the CLI
From the global configuration mode, use the qos mode command to set the type of classification
(SA, DA, Ether‐Type, 802.1p‐Tag) that you want the access point to use.
•
If you select source (SA) or destination (DA) address, you must use the qos mac‐address
command to configure at least one MAC address for the qos mode to take affect. To display
the QoS settings, use the show qos command from the Exec mode.
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#qos mode SA
RoamAbout 3000(config)#qos mac-addr 00-01-f4-32-62-ac 6
RoamAbout 3000(config)#exit
RoamAbout 3000#
RoamAbout 3000#show qos
QoS information
======================================================
QoS Mode : Source Address
------------------------------------------------------
=================================================================
====
RoamAbout 3000#
•
If you selected Ethernet Type, you must use the qos ether‐type command to configure at least
one Ethernet type classification and the priority for the qos mode to take affect. To display the
QoS settings, use the show qos command from the Exec mode.
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#qos mode ether-type
RoamAbout 3000(config)#qos ether-type 0800 6
RoamAbout 3000(config)#
RoamAbout 3000(config)#exit
RoamAbout 3000#
RoamAbout 3000#show qos
QoS information
======================================================
QoS Mode : Ethernet Type
------------------------------------------------------
======================================================
RoamAbout 3000#
4-24 Advanced Configuration
Address
00-01-F4-32-62-AC
Ether_Type
0x0800
Priority
6
Priority
6