Pppoe Local Ip - Enterasys ROAMABOUT 3000 Configuration Manual

pppoe local ip

This command sets a local IP address for the PPPoE tunnel.
Syntax
pppoe local ip <ip-address>
ip‐address is the IP address of the local end of the PPPoE tunnel.
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
If you set the pppoe ip allocation mode to static, you must use this command to specify the
local IP address and the pppoe remote ip command to set the remote IP address.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#pppoe local ip 10.7.1.200
RoamAbout 3000(if-ethernet)#
Related Commands
pppoe ip allocation mode page A‐47
pppoe remote ip page A‐52
RoamAbout Access Point 3000 Configuration Guide A-51
Command Groups