Enterasys ROAMABOUT 3000 Configuration Manual page 25

5. If your access point uses a DHCP assigned IP address go on to change the default username
and password.
Otherwise, disable DHCP for this access point as follows:
a. Type configure to enter configuration mode.
b. Type interface ethernet to access the Ethernet interface configuration mode.
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#
c. Disable DHCP. Type no ip dhcp.
RoamAbout 3000(if-ethernet)#no ip dhcp
DHCP client state has changed. Please reset AP for change to take effect.
RoamAbout 3000(if-ethernet)#exit
RoamAbout 3000#reset board
Reboot system now? <y/n>: y
Username: admin
Password:********
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#
d. Set the IP Address. Type ip address ip‐address netmask gateway, where ip‐address is the
access point's IP address, netmask is the network mask for the network, and gateway is
the default gateway router. Check with your system administrator to obtain an IP address
that is compatible with your network.
RoamAbout 3000(if-ethernet)#ip address ip-address netmask gateway
RoamAbout 3000(if-ethernet)#end
RoamAbout 3000(config)#
After configuring the access point's IP parameters, you can access the management
interface from anywhere within the attached network. The command line interface can
also be accessed using Telnet from any computer attached to the network.
6. Change the default username and password: type username and specify a unique user name;
type password and specify a unique password.
RoamAbout 3000(config)#username JadaPerl
RoamAbout 3000(config)#password G7nq1Z
Confirm new password: G7nq1Z
RoamAbout 3000(config)#
RoamAbout Access Point 3000 Configuration Guide 3-3
Initial Configuration Steps