Pppoe Service-Name; Pppoe Restart - Enterasys ROAMABOUT 3000 Configuration Manual

pppoe service-name

This command sets the service name for the PPPoE tunnel.
Syntax
pppoe service-name <string>
string is the service name assigned by the service provider. Range: 1‐63 alphanumeric
characters
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
The service name is normally optional, but may be required by some service providers.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#pppoe service-name classA
RoamAbout 3000(if-ethernet)#

pppoe restart

This command restarts the PPPoE connection with updated parameters.
Command Mode
Interface Configuration (Ethernet)
Command Usage
This command restarts PPPoE service using the most recently configured parameters.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#pppoe restart
RoamAbout 3000(if-ethernet)#
RoamAbout Access Point 3000 Configuration Guide A-55
Command Groups