Table of Contents
Advertisement
Command Groups
pppoe ipcp dns
This command requests allocation of IP addresses for Dynamic Naming System (DNS) servers
from the device at the remote end of the PPPoE tunnel.
Syntax
pppoe ipcp dns
no pppoe ipcp dns
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
DNS servers are used to translate host computer names into IP addresses. PPPoE clients can
request a primary and secondary DNS server from the network connection device at the
remote end of the PPPoE tunnel. This request is passed to the remote end during the IP
Control Protocol (IPCP) negotiation phase during session initialization.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#pppoe ipcp dns
RoamAbout 3000(if-ethernet)#
A-48
Advertisement
Table of Contents
