Pppoe Ip Allocation Mode - Enterasys ROAMABOUT 3000 Configuration Manual

pppoe ip allocation mode

This command specifies how IP addresses for the PPPoE tunnel are configured on this
interface.
Syntax
pppoe ip allocation mode {automatic | static}
• automatic ‐ IP addresses are dynamically assigned by the ISP during PPPoE session
initialization.
• static ‐ Fixed addresses are assigned by the ISP for both the local and remote IP addresses.
Default Setting
automatic
Command Mode
Interface Configuration (Ethernet)
Command Usage
The IP address allocation mode depends on the type of service provided by the ISP. If the ISP
uses DHCP to allocate dynamically the IP addresses for the PPPoE connection, select
automatic mode. If the ISP has assigned static addresses, select static and then enter the static
addresses using the pppoe local ip and pppoe remote ip commands.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#pppoe ip allocation mode static
RoamAbout 3000(if-ethernet)#
Related Commands
pppoe local ip page A‐51
pppoe remote ip page A‐52
RoamAbout Access Point 3000 Configuration Guide A-47
Command Groups