Table of Contents
Advertisement
Table A-19 VLAN Commands
Command
management-vlan
management-vlanid
vlan
native-vlanid
untagged-vlanid
Note: Before enabling the VLAN feature on the access point, you must set up the network switch
port to support tagged VLAN packets from the access point. The switch port must also be
configured to accept the access point's management VLAN ID and native VLAN IDs. Otherwise,
connectivity to the access point will be lost when you enable the VLAN feature.
Function
Enables management VLAN for the access
point
Sets the management VLAN ID for the access
point
Enables vlan on the specified radio interface
Sets the native VLAN ID for the selected radio
interface
Specifies VLANID to use for untagged packets
on the Ethernet port
RoamAbout Access Point 3000 Configuration Guide A-171
Command Groups
Mode
Page
GC
A-174
GC
A-173
IC-W
A-174
IC-W
A-175
IC-W: VAP
IC-E
A-176
Advertisement
Table of Contents
