Cli Commands For 802.1X Authentication - Enterasys ROAMABOUT 3000 Configuration Manual

Security
–

CLI Commands for 802.1x Authentication

Use the 802.1x supported or 802.1x required command from the interface wireless or interface
wireless: VAP configuration mode to enable 802.1x authentication, or the no 8021.x to disable it.
Use the 802.1x broadcast‐key‐refresh‐rate, 802.1x broadcast‐key‐refresh‐rate, and 802.1x session‐
timeout commands to set the broadcast and session key refresh rates, and the re‐authentication
timeout.
4-68 Advanced Configuration
Local MAC Filter Settings adds MAC addresses and permissions into the local MAC
database.
‐ MAC Address is the physical address of a client. Enter six pairs of hexadecimal digits
separated by hyphens; for example, 00‐01‐F4‐12‐AB‐89.
‐ Permission specifies whether to allow or deny access to this MAC address. Allow
permits access; Deny blocks access; Delete removes the specified MAC address entry
from the database.
‐ Update enters the specified MAC address and permission setting into the local
database.
‐ MAC Authentication Table displays current entries in the local MAC database.
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface wireless a
RoamAbout 3000(if-wireless a)#802.1x supported
RoamAbout 3000(if-wireless a)#802.1x broadcast-key-refresh-rate
5
RoamAbout 3000(if-wireless a)#802.1x session-key-refresh-rate 5
RoamAbout 3000(if-wireless a)#802.1x session-timeout 300
RoamAbout 3000(if-wireless a)#
RoamAbout 3000(if-wireless a)#vap 1
RoamAbout 3000(if-wireless a: VAP[1])#802.1x supported
RoamAbout 3000(if-wireless a: VAP[1])#802.1x broadcast-key-
refresh-rate 5
RoamAbout 3000(if-wireless a: VAP[1])#802.1x session-key-
refresh-rate 5
RoamAbout 3000(if-wireless a: VAP[1])#802.1x session-timeout 300
RoamAbout 3000(if-wireless a: VAP[1])#end
RoamAbout 3000(if-wireless a)#end
RoamAbout 3000#