Table of Contents
Advertisement
Command Groups
The AP 3000 commands fall into the functional command groups shown in Table
Table A-3 Command Groups
Command Group
General
System Management
PPPoE
SNMP
Flash/File
RADIUS
Authentication
Filtering
Interface
IAPP
QoS
VLANs
The access mode shown in the following tables is indicated by the following abbreviations:
•
Exec (Executive mode)
•
GC (Global Configuration)
•
IC (Interface Configuration ‐ general)
•
IC‐E (Interface Configuration ‐ configure Ethernet interface)
•
IC‐W (Interface Configuration ‐ configure wireless interface)
•
IC‐W: VAP (Interface Configuration ‐ configure the selected VAP for an interface)
Description
Basic commands for entering configuration mode, restarting
the system, or quitting the CLI
Controls user name, password, system logs, browser
management options, clock settings, and a variety of other
system information
Configures PPPoE management tunnel connection
parameters for the Ethernet port.
Configures community access strings and trap managers
Manages code image or access point configuration files
Configures the RADIUS client used with 802.1x
authentication
Configures IEEE 802.1x port access control and address
filtering
Filters communications between wireless clients, controls
access to the management interface from wireless clients,
and filters traffic using specific Ethernet protocol types
Configures connection parameters for the Ethernet port and
wireless interface
Enables roaming between multi-vendor access points
Allows you to select specific network traffic, prioritize it, and
use congestion-management and congestion-avoidance
techniques to provide preferential treatment.
Configures VLAN membership
RoamAbout Access Point 3000 Configuration Guide A-9
Command Groups
A‐3.
Page
A-10
A-16
A-45
A-57
A-76
A-81
A-88
A-101
A-106
A-153
A-154
A-170
Advertisement
Table of Contents
