Table of Contents
Advertisement
qos mode
This command allows you to set the type of classification used by the access point based on the
source address (SA), destination address (DA), Ethernet type, or 802.1p.
Syntax
qos mode <mode>
mode is the type of classification used by the access point (SA, DA, Ether‐type, or 802.1p)
Default Setting
None
Command Mode
Global Configuration
Command Usage
•
After you select SA or DA, use the qos
the priority.
•
After you select Ether‐type, use the qos
type and the priority.
•
If you select 802.1p, the priorities are based on the device (switch) attached. No further
configuration is necessary.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#qos mode SA
RoamAbout 3000(config)#
mac-addr command to enter the MAC addresses and
ether-type command to enter the Ethernet protocol
RoamAbout Access Point 3000 Configuration Guide A-155
Command Groups
Advertisement
Table of Contents
