Table of Contents
Advertisement
password
After initially logging onto the system, you should change the password. To reset the password to
the default password of password, use the no form.
Syntax
password password
no password
password is the password used for management access. Length: 3‐16 characters, case sensitive
Default Setting
password
Command Mode
Global Configuration
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#password Az24K
Confirm new password: Az24K
RoamAbout 3000(config)#
com-port
Enables or disables the Access Point 3000's com port.
Syntax
com-port <enable | disable>
enable allows access to the AP through its com port.
disable denies access to the AP through its com port.
Default Setting
Enable
Command Mode
Global Configuration
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#com-port disable
RoamAbout 3000(config)#com-port enable
RoamAbout 3000(config)#
Related Commands
show system page A‐44
RoamAbout Access Point 3000 Configuration Guide A-23
Command Groups
Advertisement
Table of Contents
