Using Web Management - Enterasys RoamAbout RBT-4102 Configuration Manual

Initial Setup Using the CLI
4. Change the default username and password: type username and specify a unique user name;
type password and specify a unique password.
RoamAbout 4102(config)#username KarenBD
RoamAbout 4102(config)#password ******
Confirm new password: ******
RoamAbout 4102(config)#
5. To specify the management VLAN ID, type management‐vlanid and specify a management
vlanid.
RoamAbout 4102(config)#management-vlanid 10
Reboot system now? <y/n>:y
Username: admin
Password:********
6. Go to Chapter

Using Web Management

To use the Web interface to minimally configure the access point, follow these steps:
1. Open a Web browser and enter the access point's IP address in the address field:
• If your access point uses a DHCP assigned IP address, make sure the access point is
• If your access point uses a static IP address, connect a system to the access point's Ethernet
The access point's Login window appears.
2. Enter the username admin and the password password, and click LOGIN (for more
information about the username and password, refer to Chapter
3-4 Initial Configuration
Note: You must set up the network switch port to support tagged VLAN packets from the access
point. The switch port must also be configured to accept the access point's management VLAN ID
and native VLAN IDs.
4 for advanced configuration.
Notes:
• The default username is admin, and the default password is password.
• To get help, click on Help, located at the bottom of the screen.
• You must click on the Apply button, located at the bottom of the each Web interface page for the
configuration to take effect.
connected to your network, and enter the DHCP assigned IP address in your browser's
address field. Use your DHCP server or other utility to determine the access point's IP
address.
port and enter the default IP address: http://192.168.1.1/ in your browser's address field.
4).