Table 3-48: Account Parameters Description - AudioCodes MediaPack MP-124 User Manual

SIP User's Manual
Parameter
Served Trunk
Group
Serving IP Group
Username
Password
HostName
Register
Version 5.6

Table 3-48: Account Parameters Description

The Hunt Group ID for which the device performs registration and/or
authentication to a destination IP Group (i.e., Serving IP Group).
For Tel-to-IP calls, the Served Trunk Group is the source Hunt Group from
where the call initiated. For IP-to-Tel calls, the Served Trunk Group is the
'HuntGroup ID' defined in the 'IP to Hunt Group Routing' table (refer to ''IP to
Hunt Group Routing'' on page 163). For defining Hunt Groups, refer to
Configuring the Endpoint Phone Numbers on page 181.
The destination IP Group ID (defined in ''Configuring the IP Groups'' on page
186) to where the REGISTER requests (if enabled) are sent or Authentication
is performed. The actual destination to where the REGISTER requests are sent
is the IP address defined for the Proxy Set ID (refer to ''Proxy Sets Table'' on
page 120) associated with this IP Group. This occurs only in the following
conditions:
The parameter 'Registration Mode' is set to 'Per Account' in the 'Hunt Group
Settings' table (refer to ''Configuring the Hunt Group Settings'' on page 183).
The parameter 'Register' in this table is set to 1.
In addition, for a SIP call that is identified by both the Served Trunk Group and
Serving IP Group, the username and password for digest authentication
defined in this table is used.
For Tel-to-IP calls, the Serving IP Group is the destination IP Group defined in
the 'Hunt Group Settings' table or 'Tel to IP Routing' table (refer to ''Tel to IP
Routing Table'' on page 160). For IP-to-Tel calls, the Serving IP Group is the
'Source IP Group ID' defined in the 'IP to Hunt Group Routing' table (refer to
''IP to Hunt Group Routing'' on page 163).
Note: If no match is found in this table for incoming or outgoing calls, the
username and password defined in the 'Authentication' table (refer to
Authentication on page 174) or the global parameters (UserName and
Password) defined on the 'Proxy & Registration' page (refer to ''Proxy &
Registration Parameters'' on page 112) are used.
Digest MD5 Authentication user name (up to 50 characters).
Digest MD5 Authentication password (up to 50 characters).
Defines the Address of Record (AOR) host name. It appears in REGISTER
From/To headers as ContactUser@HostName. For successful registrations,
this HostName is also included in the INVITE request's From header URI. If not
configured or if registration fails, the 'SIP Group Name' parameter from the 'IP
Group' table is used instead.
This parameter can be up to 49 characters.
Enables registration.
No = Don't register
Yes = Register
When enabled, the device sends REGISTER requests to the Serving IP Group.
In addition, to activate registration, you also need to set the parameter
'Registration Mode' to 'Per Account' in the 'Hunt Group Settings' table (refer to
''Configuring the Hunt Group Settings'' on page 183) for the specific Hunt
Group. The Host Name (i.e., host name in SIP From/To headers) and Contact
User (user in From/To and Contact headers) are taken from this table upon a
successful registration. See the example below:
Description
189
3. Web-Based Management
November 2008