Figure 3-91: Fxo Settings; Table 3-51: Fxo Parameters Description - AudioCodes MediaPack MP-124 User Manual

To configure the FXO parameters, take these 4 steps:
Open the 'FXO Settings' page (Configuration tab > Advanced Applications menu >
1.
FXO Settings page item).
Configure the FXO parameters according to the table below.
2.
Click the Submit button to save your changes.
3.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.
4.
Parameter
Dialing Mode
[IsTwoStageDial]
Waiting For Dial Tone
[IsWaitForDialTone]
SIP User's Manual
Figure 3-91: FXO Settings Page

Table 3-51: FXO Parameters Description

Determines the dialing mode for IP-to-Tel (FXO) calls.
[0] One Stage = One-stage dialing.
[1] Two Stages = Two-stage dialing (default).
If two-stage dialing is enabled, the device seizes one of the PSTN/PBX
lines without performing any dialing, connects the remote IP user to
the PSTN/PBX, and all further signaling (dialing and Call Progress
Tones) is performed directly with the PBX without the device's
intervention.
If one-stage dialing is enabled, the device seizes one of the available
lines (according to the parameter ChannelSelectMode), and dials the
destination phone number received in the INVITE message. Use the
parameter IsWaitForDialTone to specify whether the dialing must start
after detection of the dial tone or immediately after seizing the line.
Determines whether the device waits for a dial tone before dialing the
phone number for IP-to-Tel (FXO) calls.
[0] No = Don't wait for dial tone.
[1] Yes = Wait for dial tone (default).
When one-stage dialing and this parameter are enabled, the device
dials the phone number (to the PSTN/PBX line) only after it detects a
dial tone.
If this parameter is disabled, the device immediately dials the phone
number after seizing the PSTN/PBX line without 'listening' for a dial
tone.
196
Description
Document #: LTRT-65411
MediaPack Series