AudioCodes MediaPack MP-124 User Manual page 266

Parameter
UseTelURIForAssertedID
EnableRPIheader
IsUserPhone
IsUserPhoneInFrom
IsUseToHeaderAsCalledNumb
er
EnableHistoryInfo
SIPSubject
MultiPtimeFormat
EnableReasonHeader
EnableSemiAttendedTransfer
SIP183Behavior
EnablePtime
EnableUserInfoUsage
HandleReasonHeader
EnableSilenceSuppInSDP
SIP User's Manual
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
Determines whether the called number is set in the user part of
the To header.
[0] = Sets the destination number to the user part of the
Request-URI for IP-to-Tel calls, and sets the Contact header to
the source number for Tel-to-IP calls (default).
[1] = Sets the destination number to the user part of the To
header for IP-to-Tel calls, and sets the Contact header to the
username parameter for Tel-to-IP calls.
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
For a description of this parameter, refer to ''SIP General
Parameters'' on page 101.
Determines whether the ptime header is included in the SDP.
[0] = Remove the ptime header from SDP.
[1] = Include the ptime header in SDP (default).
For a description of this parameter, refer to ''Advanced
Parameters'' on page 129.
Determines whether the device uses the value of the incoming
SIP Reason header for Release Reason mapping.
[0] Disregard Reason header in incoming SIP messages.
[1] Use the Reason header value for Release Reason mapping
(default).
Determines the device's behavior upon receipt of SIP Re-INVITE
messages that include the silencesupp:off attribute.
[0] = Disregard the silecesupp attribute (default).
[1] = Handle incoming Re-INVITE messages that include the
silencesupp:off attribute in the SDP as a request to switch to
the Voice-Band-Data (VBD) mode.
266
MediaPack Series
Description
Document #: LTRT-65411