Figure 3-88: Account Table - AudioCodes MediaPack MP-124 User Manual

Parameter
Always Use Route
Table
3.4.4.8.3 Configuring the Account Table
The 'Account Table' page allows you to define accounts per Hunt Groups (referred to as
Served Trunk Group) or to a Served IP Group for registration and/or digest authentication
(user name and password) to a destination IP address (Serving IP Group). The Account
table can be used, for example, to register to an Internet Telephony Service Provider (ITSP)
on behalf of an IP-PBX to which the device is connected. The registrations are sent to the
Proxy Set ID (refer to ''Proxy Sets Table'' on page 120) associated with these Serving IP
Groups. A Hunt Group can register to more than one Serving IP Group (e.g., ITSP's), by
configuring multiple entries in this Account table with the same Served Trunk Group, but
with different Serving IP Groups, user name/password, Host Name, and Contact User
parameters.
Note:
To configure Accounts, take these 5 steps:
Open the 'Account Table' page (Configuration tab > Protocol Configuration menu >
1.
Hunt/IP Group submenu > Account Table page item).
To add an Account, in the 'Add' field, enter the desired table row index, and then click
2.
Add. A new row appears.
Configure the Account parameters according to the table below.
3.
Click the Apply button to save your changes.
4.
To save the changes, refer to ''Saving Configuration'' on page 209.
5.
Note:
SIP User's Manual
This parameter is disregarded if the parameter AlwaysSendToProxy is
set to 1.
Determines the Request URI host name in outgoing INVITE messages.
Disable (default).
Enable = The device uses the IP address (or domain name) defined in
the 'Tel to IP Routing' table (''Tel to IP Routing Table'' on page 160) as
the Request URI host name in outgoing INVITE messages, instead of
the value entered in the 'SIP Group Name' field.
You can also configure the Account table using the ini file table parameter
Account (refer to ''SIP Configuration Parameters'' on page 260).
Figure 3-88: Account Table Page
For a description of the Web interface's table command buttons (e.g.,
Duplicate and Delete), refer to ''Working with Tables'' on page 32.
Description
188
MediaPack Series
Document #: LTRT-65411