Figure 3-80: Automatic Dialing - AudioCodes MediaPack MP-124 User Manual

3.4.4.6.2 Automatic Dialing
The 'Automatic Dialing' page allows you to define a telephone number that is automatically
dialed when an FXS or FXO port is used (e.g., off-hooked).
Notes:
To configure Automatic Dialing, take these 5 steps:
Open the 'Automatic Dialing' page (Configuration tab > Protocol Configuration
1.
menu > Endpoint Settings submenu > Automatic Dialing page item).
In the 'Destination Phone Number' field corresponding to a port, enter the telephone
2.
number that you want automatically dialed.
From the 'Auto Dial Status' drop-down list, select one of the following:
3.
•
Enable [1]: The number in the 'Destination Phone Number' field is automatically
dialed if the phone is off-hooked (for FXS interfaces) or a ring signal (from
PBX/PSTN switch) is generated to a port (FXO interfaces).
•
Disable [0]: The automatic dialing feature for the specific port is disabled (i.e., the
number in the 'Destination Phone Number' field is ignored).
SIP User's Manual
•
After a ring signal is detected on an 'Enabled' FXO port, the device
initiates a call to the destination number without seizing the line. The line
is seized only after the call is answered.
•
After a ring signal is detected on a 'Disabled' or 'Hotline' FXO port, the
device seizes the line.
•
You can also configure automatic dialing using the ini file table parameter
TargetOfChannel (refer to ''Analog Telephony Parameters'' on page 279).
•
You can configure the device to play a Busy/Reorder tone to the Tel side
upon receiving a SIP 4xx, 5xx, or 6xx response from the IP side (i.e., Tel-
to-IP call failure), using the ini file parameter FXOAutoDialPlayBusyTone
(refer to ''SIP Configuration Parameters'' on page 260).
Figure 3-80: Automatic Dialing Page
176
MediaPack Series
Document #: LTRT-65411