Figure 3-79: Authentication - AudioCodes MediaPack MP-124 User Manual

SIP User's Manual
3.4.4.6.1 Authentication
The 'Authentication' page defines a user name and password for authenticating each
device port. Authentication is typically used for FXS interfaces, but can also be used for
FXO interfaces.
Notes:
To configure the Authentication Table, take these 5 steps:
Set the 'Authentication Mode' parameter to 'Per Endpoint' (refer to ''Proxy &
1.
Registration Parameters'' on page 112).
Open the 'Authentication' page (Configuration tab > Protocol Configuration menu >
2.
Endpoint Settings submenu > Authentication page item).
In the 'User Name' and 'Password' fields corresponding to a port, enter the user name
3.
and password respectively.
Click the Submit button to save your changes.
4.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.
5.
Version 5.6
•
The 'Authentication Mode' parameter (refer to ''Proxy & Registration
Parameters'' on page 112) determines whether authentication is
performed per port or for the entire device. If authentication is performed
for the entire device, the configuration in the 'Authentication' page is
ignored.
•
If either the user name or password field is omitted, the port's phone
number (defined in Configuring the Endpoint Phone Numbers on page
181) and global password (refer to the parameter 'Password' described in
''Proxy & Registration Parameters'' on page 112) are used instead.
•
You can also configure Authentication using the ini file table parameter
Authentication (refer to ''SIP Configuration Parameters'' on page 260).
Figure 3-79: Authentication Page
175
3. Web-Based Management
November 2008