Using Service Program Modes; Accessing Sp Modes; Entering Sp Mode; Leaving Sp Mode - Ricoh C231 Service Manual

5. SERVICE PROGRAM MODE

NOTE: The Service Program Mode is for use by service representatives only so
that they can properly maintain product quality. If this mode is used by
anyone other than service representatives for any reason, data might be
deleted or settings might be changed. In such case, product quality cannot
be guaranteed any more.

5.1 USING SERVICE PROGRAM MODES

Use the service program modes (SP modes) to check electrical data, change
operating modes, and adjust values.

5.1.1 ACCESSING SP MODES

Entering SP Mode

1. Key in the following sequence.
→ → →
• Hold the
key down for longer than 3 seconds.

Leaving SP Mode

Press the key one or more times.
SM
→
5-1
ACCESSING SP MODES
C267