Sp6-100 To 104: Paper Registration - Each Speed - Ricoh C231 Service Manual

5.7.11 SP6-100 TO 104: PAPER REGISTRATION - EACH SPEED

The following procedure allows the image position to be adjusted for each speed
(30, 60, 80, 100 and 130 rpm)
NOTE: If you want to adjust the image position for all the speed at the same time,
use SP6-21 (Paper registration position).
1. Set SP8-10 (Test patterns) to a value of "6", then press the Start key.
2. Make 3 copies at speed 3 (finishing with 130 rpm). Perform the adjustment
below for all 3 copies.
Trial print: 30 rpm
1st print: 60 rpm
2nd print: 80 rpm
3rd print: 100 rpm
4th print: 130 rpm
3. The distance between the leading edge and first line should be 8mm, as shown
below.
4. If this distance is not 8mm, access SP6-101 to 104 and then input a value to
adjust the distance (range: -40 to 40, step: 1) for each of 3 copies samples (i.e.
30, 60, 80, 100 and 130 rpm samples).
The higher the value, the narrower the distance between the leading edge and
1st line becomes (and vice-versa). Also, each step corresponds to
approximately 0.5mm. Input the value that will bring the distance to 8mm.
5. Perform the adjustment again for any of the samples that are still outside the
8mm standard.
NOTE: Adjust SP6-108 to 112, 132 to 144 in the same way.
SM
SP6-100 TO 104: PAPER REGISTRATION - EACH SPEED
5-17
C267S905.WMF
C267