Ricoh C231 Service Manual page 404

MAIN MENU NO.2: BASIC SETTINGS
5.3 MAIN MENU NO.2: BASIC SETTINGS
5.3.1 SP TABLE
No.
2-1 Default print speed
2-2 Default image position
2-10 Ink detection board
2-11 Paper end sensor
2-12 Drum master sensor
2-13 Platen cover sensor
2-14 ADF cover sensor
2-20 Destination setting
2-21 Swap start key for print key
2-22 Double count-up for A3 masters
2-24 Slow Starting Mode
2-33 Re-Feeding
2-40 T/H energy control by ink temperature
2-41 Thermal head energy control
2-42 Thermal head energy control - economy
⇒
2-95 Paper Table Standby Position
5.3.2 SP2-41, 2-42: THERMAL HEAD ENERGY CONTROL
2-41: The default is 7%. This means that during normal printing mode, the thermal
head energy is 93% of the maximum possible (100 – 7).
2-42: The default is 10%. This means that in economy printing mode, the thermal
head energy is reduced by another 10%. With the default settings, this
means that the thermal head energy is 83% of maximum power (100-7-10).
C231/C237/C238
Menu Items Default
3 1 to 5
4 1 to 7
1: -15mm, 2: -10mm, 3: -5mm,
4: 0.0mm, 5: +5mm, 6: +10mm,
7: +15mm
On Off/On (Off is used for tests, and
for removing ink from the drum –
section 3.8.)
On Off/On (Off is used for tests.)
On Off/On (Off is used for tests.)
On Off/On (Off is used for tests.)
On Off/On (Off is used for tests.)
- 0: Japan, 1: NA, 2: EU
Off Off/On
0 0: Not used, 1: Master counter
only, 2: Master counter and print
counter
1 1, 2, 3, 4 (
On On/Off Factory = On (
On Off/On
7 0 to 50%
10 0 to 43% (
Off On/Off Factory = Off (
5-6
Rev. 03/2006
Settings
5.3.3)
5.3.4)
5.3.2)
5.3.5)
SM