Introduction; System Requirements - Ricoh C231 Service Manual

The Priport Controller is an external raster image processor designed to add a computer interface to Priport Digital
Duplicators. Since it is separate from the Priport, the designers were able to use high-speed techniques making it
one of the fastest add-on processors available.
The Controller uses a high-speed 25-megahertz Intel 960-CA RISC microprocessor chip to achieve its high speed
processing. In addition, the PCRIP-EZ1 Controller contains 4 Megabytes (MB) of RAM that can be upgraded to 8
MB or 16 MB.
This program features Computer:applications, Inc. DigiPrint
The DigiPrint drivers for Windows 3.1 and Windows 95 on the PC support the Graphic Device Interface (GDI)
and all True Type Fonts. The DigiPrint Driver for the Macintosh supports system fonts and True Type fonts.
Utility and Monitor programs for the Macintosh are also provided.
The PCRIP-EZ1 Controller is a GDI controller, that is, it does not recognize PCL or PostScript.
The Controller supports several models of Priport Digital Duplicators with print resolutions from 300 dots per inch
(dpi) to 400 dpi. The U.S. page sizes supported by the Priport Controller are US Letter, US Legal and US 11 x 17.
Supported international page sizes are A3, A4, B4 and B5.
We reserve the right to make amendments to the technical specifications and/or the external appearance of the
equipment without prior notice.
Supported Priports:
- Models VT1730, VT1800, VT2105, VT2200, VT2250, VT2400, VT2600, VT3500, VT3600, VT3800 and
JP1030
Compatible computers:
- IBM 486, Pentium and compatible PC's
- Apple Macintosh Peforma 630 or higher
Memory requirements:
- This Priport Controller requires 8Mb of the RAM in the PC or Macintosh.
User's Guide

INTRODUCTION

SYSTEM REQUIREMENTS

8-1
software for both PC and Macintosh platforms.
PCRIP-EZ1