Ricoh C231 Service Manual page 405

Rev. 03/2006
5.3.3 SP2-24: SLOW STARTING MODE
Setting Trial print
1 30 rpm
2 15 rpm
3 15 rpm
4 15 rpm
The figures above are drum rotation speeds. A setting of 2, 3, or 4 will increase the
image density of trial prints.
5.3.4 SP2-33: RE-FEEDING
Purpose: When the machine performs re-feeding, the paper registration position
can be up to 5 mm out of range. If this incorrect position is not acceptable to the
customer, change this SP mode to "OFF".
ON: Re-feeding is on (factory setting).
OFF: Re-feeding is off.
⇒
5.3.5 SP2-95: PAPER TABLE STANBY POSITION
Sets whether the paper feed table will return to the lower standby position
(standard) or the upper standby position. With this SP mode, the paper tray
standby position can be changed to a higher position. As a result, the First Print
time for the next job will be about 3 seconds faster.
ON:
OFF (default):
NOTE: In the following cases, the paper feed table returns to the lower (standard)
standby position even if SP2-95 is ON. This is to make sure that the master
making unit does not touch the paper feed table.
When the Master End condition occurs
When a B-jam (Master Eject Jam) or a D-jam (Master Feed Jam)
occurs
When the paper height sensor is activated at main power ON
SM
Skip feed 1st print 2nd print 3rd print 4th print 5th print
None 60 rpm
None 30 rpm
15 rpm(1time) 60 rpm
15 rpm(1time) 30 rpm
The paper feed table returns to the upper standby position
after printing or master-making.
The paper feed table returns to the lower (standard) standby
position after printing or master-making.
5-7
MAIN MENU NO.2: BASIC SETTINGS
75 rpm 90 rpm 105 rpm 120 rpm
60 rpm 75 rpm 90 rpm
75 rpm 90 rpm 105 rpm 120 rpm
60 rpm 75 rpm 90 rpm
105 rpm
105 rpm
C231/C237/C238