Ricoh C231 Service Manual page 132

INSTALLATION PROCEDURE
8. Remove the small cap in the rear
cover of the main body [A]. Then,
connect the tape marker harness
[B] to the main body, and install the
connector cover [C] using one of
the rear cover securing screws.
9. Open the tape marker cover [D].
Then, insert the leading edge of
the tape into the tape entrance until
it stops as shown in the illustration
[E].
NOTE: Be sure that the tape is
installed in the proper
direction. If it is not, the
tape marker will not work
correctly.
10. Turn on the main switch of the main
body, access the SP mode and set
SP No.5 to "1" to activate the tape
marker. (Refer to the section 4.4.2.)
11. Turn on the tape marker switch [F].
12. Press the tape cut button [G] to cut
off the leading edge of the tape.
13. Check the tape marker operation
using the Memory/Class modes of
the main body.
C231/C237/C238
[A]
[C]
[E]
[F]
[G]
3-16
[B]
C231I518.PCX
[D]
C231I519.PCX
C231I520.PCX
C231I521.PCX
SM