Priport Controller Configuration; Factory Settings; Controller Configuration Program; Configuration Of Ibm Pc And Compatibles - Ricoh C231 Service Manual

PRIPORT CONTROLLER CONFIGURATION

1.

Factory Settings:

The Controller comes preset with the following factory defaults:
- Input Buffers:
- Page Size:
- Mode:
2. Controller Configuration Programs:
Two utility diskettes have been provided with the Controller: One 3 1/2" for IBM and compatible computers
and one 3 1/2" for Apple Macintosh computers. Each of these configuration programs allows you to change
the factory settings of the Controller (including the ones listed above) until the next power down of the
Controller or permanently if desired.
NOTE: See Step 9 on page 5 on how to save configuration changes you have made using the PC
Configuration Program. See Step 5-6 on page 6 on how to save configuration changes you have made
using the DigiPrint Utility for the Macintosh.

CONFIGURATION OF IBM PC AND COMPATIBLES

The vast majority of users will never need to use the configuration program to change the factory default settings
listed above.
The most likely uses for the configuration program will be to change input buffer size (if connected to a PC), print
the diagnostic status page or a test file, enable/disable AppleTalk (if connected to PC only), save configuration
changes or change the default table. If there is a need to change the configuration, the menu-driven program has
been designed to be very simple to use. When the initial configuration is completed and saved, you should rarely
need to use this program disk again.
Due to changes in the firmware and driver for the PCRIP-EZ1, it is no longer necessary to change the paper
size settings with the configuration program design as it was with the PCRIP-10 Controller. The driver will
automatically transmit the page size selected in the document to the controller. The inter-job timeout value
needs to be changed only if both a PC and a Macintosh are connected to one Controller.
User's Guide
Parallel Inputs - 256 KB
AppleTalk - Not applicable
US Letter (8-1/2" x 11") in US and Canada
A4 (210mm X 297mm) for International
Windows Graphical Device Interface (GDI) and
Macintosh QuickDraw (QD)
8-3 PCRIP-EZ1