Mvme761 Transition Module Installation - Motorola MVME2700 Series Installation And Use Manual

Hardware Installation

MVME761 Transition Module Installation

3
3-14
This section applies to MVME761-compatible models of the MVME2700
VMEmodule. With the MVME2700 installed, refer to
proceed as follows to install an MVME761 transition module:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VMEmodules.
3. Remove the filler panel(s) from the appropriate card slot(s) at the
front or rear of the chassis. (You may need to shift other modules in
the chassis to allow space for the cabling to the MVME761.)
4. Attach the P2 adapter board to the P2 backplane connector at the slot
occupied by the MVME2700 VMEmodule.
Figure 3-4
Computer Group Literature Center Web Site
and