Table of Contents
Advertisement
Transition Module Preparation and
5
Installation
5.1
Overview
This chapter provides hardware preparation and installation instructions for the CPCI-6115-
MCPTM transition module. Refer to
assignments.
The CPCI-6115-MCPTM transition module provides additional I/O capabilities to the CPCI-
6115 SBC. The transition module is installed directly in the CompactPCI backplane in the rear
transition board bay of the chassis and interfaces with the CPCI-6115 SBC through the J3 and
J5 connectors.
Rear panel connectors on the CPCI-6115-MCPTM include one of two configurations: two RJ-
45 connectors for 10/100/1000BaseTx Ethernet and one RJ-45 connector for asynchronous
serial port, COM1 (CompactPCI version); or four RJ-45 connectors for asynchronous serial
ports, COM1, COM2, COM3 and COM4 (MXP version). Only COM1 and COM2, however, are
available on the CPCI-6115 SBC for use with the transition module. An additional two serial
ports and the one EIDE channel are available on J3 and J5 from the baseboard.
The transition module supports two single-wide (74mm wide by 69mm long) PMC I/O modules.
PMC I/O pins 1 through 64 of each PMC slot on the CPCI-6115 SBC are routed from the J3
and J5 connectors to the PMC I/O (PIM1 and PIM2) on the transition module. For a detailed
description of PMC I/O modules refer to the section titled
Before installing your transition module, ensure that you have performed all tasks as described
in
Chapter 2, Hardware Preparation and Installation
configuring and installing the transition module.
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
Chapter 3, Controls, LEDs, and Connectors
PMC I/O Modules on page
for installing the CPCI-6115 prior to
5
for pin
104.
89
Advertisement
Table of Contents
