Mvme761 Transition Module - Motorola MVME2700 Series Installation And Use Manual

The features of the P2 adapter board include:

MVME761 Transition Module

The MVME761 transition module
used in conjunction with the models of the MVME2700 VMEmodule as
listed in
The features of the MVME761 include:
http://www.mcg.mot.com/literature
Green LED for SCSI terminator power; yellow LED for Ethernet
transceiver power
A 50-pin connector for SCSI cabling to the MVME712M and/or to
other SCSI devices
Socket-mounted SCSI terminating resistors for end-of-cable or
middle-of-cable configurations
Fused SCSI terminator power developed from the +5Vdc present at
connector P2
A 64-pin DIN connector to interface the EIA-232-D, parallel, SCSI,
and Ethernet signals to the MVME712M
MVME761 Transition Module Preparation
A parallel printer port (IEEE 1284-I compliant)
An Ethernet interface supporting 10Base-T/100Base-TX
connections
Two EIA-232-D asynchronous serial ports (identified as
on the front panel)
COM2
Two synchronous serial ports (
panel), configurable for EIA-232-D, EIA-530, V.35, or X.21
protocols
Two 60-pin Serial Interface Module (SIM) connectors
(Figure 2-11) and P2 adapter board are
on page 2-18.
and
SERIAL 3 SERIAL 4
Block Diagram
5
and
COM1
on the front
5-25