Motorola MVME2700 Series Installation And Use Manual page 189

Introduction
D
D-2
Table D-1. Troubleshooting MVME2700 Boards (Continued)
Condition Possible
Problem
II. There is a A. The keyboard
display on the or mouse may
terminal, but be connected
input from the incorrectly.
keyboard
B. Board jumpers
and/or mouse
may be
has no effect.
configured
incorrectly.
C. You may have
invoked flow
control by
pressing a
HOLD
PAUSE
by typing:
<CTRL>-S
III. Debug prompt A. Debugger
EPROM/Flash
PPC1-Bug>
does not may be
appear at missing
powerup, and
B. The board may
the board
need to be
does not
reset.
autoboot.
Recheck the keyboard and/or mouse connections
and power.
Check the board jumpers per this manual.
Press the or
HOLD
If this does not free up the keyboard, type in:
<CTRL>-Q
or
key, or
1. Disconnect all power from your system.
2. Check that the proper debugger EPROM or
debugger Flash memory is installed per this
manual.
3. Reconnect power.
4. Restart the system by "double-button reset":
press the
RESET
same time; release
seconds, then release
5. If the debug prompt appears, go to step IV or
step V, as indicated. If the debug prompt does
not appear, go to step VI.
Computer Group Literature Center Web Site
Try This:
key again.
PAUSE
and switches at the
ABORT
first, wait seven
RESET
.
ABORT